The importance of draining pool water

The draining action of the pool must be done in specific situations. This is because, unlike the filtration method, when draining the water, it is discarded – either directly in the sewage system or to be reused to irrigate the garden, for example.

It is important to note that to drain the pool, it must be empty. In other words, this is a maintenance and care process that must be performed in specific situations. Some cases that require knowing how to drain the pool are: when there is a renovation in the pool area or the need for an emergency repair.

Also, water is drained when there is a lot of dust at the bottom of the pool. This is because when this dust is very fine, the filter cannot retain it. Also, when the dirt is very dense, the filter is impaired. Thus, part of this waste can return to the pool. As a result, the water is not as clean as it should be.

To do this safely, check out a step by step:

How to drain a pool in 6 steps

1. Safety first

To drain the pool you need to empty it right? So: tell all residents that you will do this. Isolate the area to avoid possible accidents. Also, to avoid any electrical problems, turn off the underwater switches and lights that may be connected to the pool.

2. Will it be necessary to rely on a pump?

If your pool has a bottom drain in the deepest part, drainage can be done directly by it. In this way, the water will go directly to the sewer network. However, if this is not the case, it may be necessary to use an immersion pump for drainage. This material can be rented at a specific pool supply store – along with hoses that help to empty the pool.

You may also like to read how to unclog a toilet with poop in it. To know more visit our Home renovation blog http://hdecorideas.com/.

3. Where will the water go?

Also, before starting the drainage, check where the water will be deposited. Will it go directly to the sewer or will it be reused in a sustainable way, such as for garden irrigation, for example?

4. Starting drainage

If you use a pump for drainage, turn it on and stay close to the pool. Remember that the drainage time varies according to the size of the pool and the power of the pump.

Make sure the process is going as it should. If the pool’s dirt is very dense, it can hinder the passage of water through pipes/hoses. Therefore, if the hoses become clogged, turn off the pump and clean them. Only turn the pump on again when the pipes are clear.

Also, take advantage of the moment when the pool is emptying to wash it. To do this, use a hose and scrub the walls of the pool with a broom. This action will save a good amount of time at the end of the drainage, in which it will be necessary to remove possible residues that do not come out with the action.

5. Is there any water left in the pool? Remove with a bucket – and finish cleaning

As powerful as the pump is, it is possible that there is little water in the pool. Therefore, remove this excess with a bucket, ensuring that the pool is completely empty.

Also, take this time to finish cleaning the pool by brushing the dirty parts. In the end, vacuum the bottom of the pool, clean the calcium deposits. On the market, there are products made especially for the removal of calcium, slime, and rust.

6. Finally: fill the pool

The water was completely drained and the pool was clean, right? Now, it’s time to refill it. To do this, connect the hoses, throw them in the pool and wait for the water to rise. To avoid having to stay by the pool all the time, estimate how long it will take for this action to be complete.

Okay, now you know how to drain the pool if you need to do this! Did you have any questions on the subject? Comment or contact us!

The post How to drain a pool in 6 steps first appeared on The Binder Blog.